Three Appointment Duplicate Dentap Proceedure - Kaylor Dental Lab, Inc.

Kaylor Dental Lab, Inc.
619 N. Florence
Wichita, KS 67212-2136
316-943-3226 -- out of Wichita, call 1-800-657-2549
E-mail: sales@kaylordental.com

Laser Welding & Repair

Denture Department

"Three Appointment" Duplicate Denture

Accu-Dent® System 1

Neutral Zone Dentures

Dento Profile Scales

"Three Appointment" Duplicate Denture Procedure

First Appointment

Place tissue treatment material in dentures. This will stabilize the denture.	Take bite.	Materials that are in the “Three Appointment” Duplicate Denture system kit.	Mix 1 scoop of White and 1 scoop of Blue putte and knead together for 15 seconds.

Roll putte into rope shape and press into tissue side of denture.	Press denture into short/top side of tray.	Close tray, this will help with clean up of excess materials.	Make sure that excess material is cleaned around all edges of tray.

Fill in all void areas.	Spray with release agent.	Spread release agent evenly over denture and base.	Snap lid closed.

Materials you will need to finish duplication of denture.	Pour entire contents of small container into large container.	Thoroughly mix contents for 15 seconds.	Pour contents slowly into base of tray.

Let material set for 5 minutes minimum.	Open lid slowly.	Remove blue base from tray and check for voids.	After checking for voids remove denture from tray.

Any voids in impression should be repaired with poly vinyl.	Take shade of old denture.	Review duplicate denture worksheet for all changes to new denture.	Send Rx, worksheet, bite and trays to lab for second appointment.

Second Appointment

You will receive upper and lower wax try-in for your second appointment.	These are the materials you will need to complete the second appointment.	Use the GC Reline Soft to border mold the denture.	Place material across the post dam area.

Place denture in patient’s mouth, use firm pressure in the palate, and hold for 15 seconds.	Guide patient into closed bite position, hold for 4 minutes.	Place any light body C & B material in patient’s denture.	Place small amount of material across palate.

Place denture in patient’s mouth, use firm pressure in the palate, and hold for 15 seconds.	Guide patient into closed bite position, hold for 4 minutes.	C & B material will fill in all void areas.	Take bite with any C&B bite material and send back to lab with prescription to make changes and/or to finish.

THIRD APPOINTMENT

Third appointment is finished dentures with a complimentary denture brush.	Upper & lower milled in occlusion, (Estep occlusion).	Another Happy Patient!

© Copyright Pen Publishing Interactive